Alto TMX 120DFX

Fiche technique

Input Channels

Microphone Input: Electronically Balanced
Frequency Response: 20 Hz to 20 kHz, +/-1 dB
Distortion (THD&N): ＜0.03% at 0 dBu, 1 kHz
Gain range 0 dB to 45 dB (Mic)
SNR (Signal-to-Noise Ratio): 115 dB

Line Input: Electronically Balanced (Unbalanced)
Frequency Response: 20 Hz to 20 kHz, +/- 1 dB
Distortion (THD&N): ＜0.03% at 0 dBu, 1 kHz
Gain range: -15 dBu to 30 dBu
Impedance Microphone Input: 1.4 kOhms
Channel Insert return: 2.5 kOhms
All Other Input: 10 kOhms or Greater
Tape Out: 1 kOhms
All Other Outputs 120 Ohms

Equalization
Hi Shelving: ±15 dB @ 12 kHz 
Mid bell:  ±12 dB @ 100 Hz - 8 kHz 
Low shelving: ±15 dB @ 80 Hz 
MAIN EQ 9 EQ: (63 Hz, 125 Hz, 250 Hz, 500 Hz, 1 kHz, 2 kHz, 4 kHz, 8 kHz, 16 kHz) ±15 dB
DSP Section: A/D and D/A Converters 24-bit
DSP Resolution: 24-bit

Type of effects
Large Hall, Medium Hall, Large Room, Medium Room, Karaoke, Short Spring Reverb, Long Spring Reverb, Chamber, Mono Delay, Mono Echo, Stereo Echo, Flanger, Chorus, Reverb + Chorus, Reverb + Delay, Thickener
Presets 16
Controls 16-Posistion Preset Selector

Clip LED
Mute switch with peak LED indicator

Main Mix Section Noise (Bus noise)
Fader 0 dB, Channels muted: -90 dBr (ref.: +4 dBu) 
Fader 0 dB, All input channels assigned and set to Unity Gain: -88 dBr (ref.: +4 dBu)

Power Consumption Stereo mode
2 x 500 W @ 4 Ohm (EIAJ)  2 x 340 W @ 4 Ohm (RMS)

Bridge mode
1000 W @ 8 Ohm (EIAJ)

Phantom Power (Mic Pin 2 / Pin 3 and Pin 1): 47 ±2 V

Power supply Main voltage 115 V / 230 V

Dimensions (WxLxH): 565mm x 450mm x 145mm
Weight: 23.5 lb

Produits complémentaires